Intimidator Spot 150 Service Maintenance Guide
Symptom(s)
Possible Solution(s)
Lamp is not illuminating | Clean the fixture regularly to avoid any such failure. This fixture is forced | ||
convection cooled, which means that if the fans are kept clean and free of | |||
| |||
| debris, then proper cooling will be allowed to occur | ||
| Check the options in the display for Lamp function [on~off]. Also check the | ||
| DMX signal. It is possible to remotely turn off the lamp with a DMX controller. | ||
| Check to see if the lamp needs to be replaced. This is a wear item, and will | ||
| need to be checked and replaced on a regular basis of operation. | ||
Breaker/Fuse keeps blowing | Check total load placed on the electrical circuit | ||
| Check for a short in the electrical wiring: internal and/or external | ||
Device has no power | Check device’s fuse (internal) |
| |
| Check for power on Mains |
| |
| |||
| repair; however, a replacement part can be ordered directly from Chauvet | ||
|
| Part#: | |
Fixture is not responding to DMX | Check Control Panel settings for correct addressing | ||
|
|
| |
| Check DMX cables |
| |
|
| ||
| Check polarity switch settings on the controller | ||
|
|
| |
| Check cable connections |
| |
|
|
| |
| Call service technician |
| |
|
| ||
| |||
| ordered directly from Chauvet | Part#: | |
Loss of signal | Use only DMX cables |
| |
|
|
| |
| Install terminator |
| |
|
| ||
| Note: Keep DMX cables separated from power cables or black lights | ||
|
| ||
Pan/tilt movement, color, gobo | 1 or more sensors may need to be adjusted or replaced. This may be either | ||
reset problem | the optical sensor or the magnetic stopper sensor. | ||
| Note In the event of a sensor failure, a replacement sensor may be ordered | ||
| directly from Chauvet: | Part#: Magnetic Pan: | |
|
| Optical Pan: | |
|
| Magnetic Tilt: | |
|
| Optical Tilt: | |
|
| Gobo: | |
|
| Gobo rotation: | |
|
| Color: | |
The display backlight will not turn | There is an option in the control board that determines if the display turns off | ||
off and stays lit | after 30 seconds of inactivity, or if the display stays lit indefinitely. | ||
|
If you still have a problem after trying the above solutions, please contact CHAUVET Technical Support at the location on the following page.
Intimidator™ Spot 150 User Manual | 23 | 6/19/2009 9:08 AM |