Configuration
(Standalone)
Sound Active Mode
Set the product in one of the standalone modes to control without a DMX controller.
1.Connect the product to a suitable power outlet.
2.Turn the product on.
Never connect a product that is operating in any standalone mode (either Automatic or Sound) to a DMX string connected to a DMX controller. Products in standalone mode may transmit DMX signals that could interfere with the DMX signals from the controller.
To enable the Sound Active mode, do the following:
1.Press <MODE/ESC> repeatedly until one of the following shows on the display: NASl, NAFA, NStS, SLAv
2.Press <UP> or <DOWN> to select NStS.
3.Press <ENTER>.
4.Turn the music on and adjust the microphone sensitivity knob until the product starts responding to the beat of the music.
Automatic Mode
Manual Pan/Tilt Operation
Pan/Tilt Angle Restrict
Display
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic Mode:
1.Press <MODE/ESC> repeatedly until one of the following shows on the display: NASl, NAFA, NStS, SLAv
2.Press <UP> or <DOWN> to select NASl (for a slow light show) or NAFA (for a fast light show).
3.Press <ENTER>.
To select whether you want the Intimidator™ Spot LED 350 to operate with normal panning or inverted panning, do the following:
1.Press <MODE/ESC> repeatedly until PAn shows on the display.
2.Press <UP> or <DOWN> to select normal pan operation (PAn) or inverse pan operation (r PAn).
3.Press <ENTER>.
To select whether you want the Intimidator™ Spot LED 350 to operate with normal tilting or inverted tilting, do the following:
1.Press <MODE/ESC> repeatedly until tiL shows on the display.
2.Press <UP> or <DOWN> to select normal pan operation (tiL) or inverse pan operation (r tiL).
3.Press <ENTER>.
You are able to restrict the pan and tilt angles on the Intimidator™ Spot LED 350 to achieve the effect you like.
To select which pan angle to use, do the following:
1.Press <MODE/ESC> repeatedly until PA54 shows on the display.
2.Press <UP> or <DOWN> to select either 540° (PA54), 360° (PA36) or 180° (PA18).
3.Press <ENTER>.
To select which tilt angle to use, do the following:
1.Press <MODE/ESC> repeatedly until Ti27 shows on the display.
2.Press <UP> or <DOWN> to select either 270° (Ti27), 180° (Ti18) or 90° (Ti 9).
3.Press <ENTER>.
You are able to flip the LED display for easy readability in any mounting situation. To select your display angle:
1.Press <MODE/ESC> repeatedly until diS shows on the display.
2.Press <UP> or <DOWN> to select normal display mode (diS) or inverse display mode (r diS).
3.Press <ENTER>.
Intimidator™ Spot LED 350 User Manual (Rev. 4) | Page 15 of 19 |
