Intimidator™ Spot LED 350 User Manual (Rev. 4) Page 7 of 19
3. SETUP
AC Power
The Intimidator™ Spot LED 350 has an auto-
ranging power supply and it can work with
an input voltage range of 100~240 VAC, 50/60 Hz.
To determine the product’s power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product’s back panel, or
refer to the product’s specifications chart. The listed current rating indicates the
product’s average current draw under norma l condition s.
Always connect the product to a protected circuit
(circuit breaker or fuse). Make
sure the product has
an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to
a rheostat ( variable resistor) or dimmer ci r cuit, even
if the rheostat or dimm er channel serves only as a 0 to 100% switch.
Fuse
Replacement
Follow the instructions below to change the fuse , if ne cessary.
Disconnect the product from the power outlet before replacing the fuse.
1. Disconnect this product from the power outlet.
2.
Using a Philli ps #2 head screwdriver, unscrew the fuse hol der cap from the housing.
3. Remove t he b lown fuse a nd rep lace with a go od fuse of the same type and rating.
4. Sc rew the fus e holder ca p bac k i n place an d recon nec t p ower .
The product does not ship with a spare fuse; however, the safety cap has room
f or a sp are.