Connecting (Cabling) Each MVP™

-14- MVP™ (12/18/37.5) Seri es Getting Started Us er Manual, Rev. 10
Connecting
Power and
Signal Cables
The following sections provide inform ation and diagram s on connecting signal and power
between panels.
One Neutrik® etherCON® signal cable and one Neutrik® powerCON® power cable are
included with each MVP™ package—one cable of each kind per MVP™ in the package.
These cables are to be used for panel linking only. You are abl e to purchase addit ional
cables.
Refer to the Introduction or Operation sections in this User Manual for available cables
and item numbers.

Connecting

the Signal

Between

Joined Panels

Signal cable panel connections can use several different configurations.
The basic
configuration to connect the signal from one panel to the next is as follows.
· The source signal is connected to the first panel’s Signal Input or Output.
· A signal cable is then connected to the first panel’s Signal Output and connected
to the next panel’s Signal Input.
· The connections continue until all panels are connected.
· The direction of the cables used to make the signal connections can vary.
The following diagrams are recommended suggestions for signal connecti ons between 24
or less panels, and more than 24 panels.
Refer to Connecting Signal Input for informati on and i nstruct ions on con nect ing t he signal
from the source.
This diagram shows an example of a simple signal connection using 24 or less
MVPs.
Signal Out to Next
Panel Above
Signal
Power

MVP™ Driver

DVI-D

Video Signal Cable in from
MVP™ Driver – Max. cable
length 100 m/328 ft
Signal Out to Next Panel
1