Mounting
Orientation
The LED PAR
Rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. Use a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm in size. When rigging, consider routine maintenance and control panel access. Please see the following notes on installation.
•Be sure to orient the gel frame release so that it is pointing up. Please see the diagram below for a visual reference.
•If you intend to use the power link out with multiple fixtures, consider the length of each power cable, and mount the fixtures close enough to one another to account for this.
•When aiming the fixtures, you may use the bracket adjustment knob. Loosen the knob, adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use tools for this step, as it may cause damage.
•Use the secondary bracket for floor standing applications.
•Always use safety cables.
Mounting
Bracket
Secondary bracket (used primarily for standing position)
Do not use a tool on the bracket adjustment knob
Aim the fixture with the gel frame release pointing up, (as shown in this diagram)
3. Setup | 7 | 9/13/2010 2:33 PM |
