Setup
Gobo
Replacement
1.Turn the product off and disconnect from the power outlet.
2.Open the head cover by loosening the four fastening screws at the sides of the top cover.
3.Separate the gobo plate from the gobo wheel by pushing the gobo plate toward the front of the moving head (direction 1 in the diagram). Be careful not to push the gobo out of the gobo plate.
4.Take out the gobo plate by pulling the gobo plate outward (direction 2 in the diagram).
5.On a flat surface, remove the expansion ring that holds the gobo in place.
6.Remove the gobo from the gobo plate.
7.Insert a new gobo and hold in place with the expansion ring.
8.Slide the tip of the gobo plate under the pressure plate near the center of the gobo wheel.
9.Push the gobo plate inward. DO NOT force the gobo plate into the gobo wheel slot.
Note: If correctly installed, the gobo plate should easily snap into the gobo wheel slot.
Gobo Plate #1 contains a magnet used by the product for positioning purposes. When replacing gobos, be sure to return gobo plate #1 to position #1 on the wheel.
