SETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST ALL AT I ON
C
DE
A 
B
Lamp plate
Foll ow this directi on to open cover
W a rn in g!
Be sure todisconnect unit frompower before Changingl amps or opening theunit cover.
Lampbecomes hot duringoperation.allow time (at l east 15 minutes)to cool beforehanding.donot
Look directly at l amp when l it.
I NSIDE |
|
|
Turn screws A & B to adjust horizontal position. | A | B |
Turn screw C toadjust vertical position. |
|
|
Turn screwsA, B & C clockwise to increase | D | E |
the diameter of the light beam. | ||
Turn screws A, B & C |
|
|
reduce the diameter of the light beam. |
|
|
Removethel amp cover by turning screws D & E |
| C |
ON
OFF
POWER SWITCH
Back cover plate
1)Remove the back cover plate by removing all 8 screws on the rear of the fixture.
2)Remove the screws (D) and (E) on the lamp plate. Pull out the lamp cover plate.
3)With lamp socket plate out and the lamp accessible, if replacing the lamp, remove old lamp first.
4)Holding the new lamp by its base, align the small pin
on the lamp with the small hole in the socket and insert |
| A | B | |
|
|
| ||
the lamp squarely until the retaining clips on the lamp |
|
|
| |
socket secures the lamp tightly. | D | Remove these | E | |
5) Clean the glass/envelope of the bulb with an alcohol | screws to | |||
|
| |||
| install or |
| ||
wipe or equivalent. |
| replace lamp |
| |
6) Holding the lamp plate, insert the tip of the lamp into |
|
|
| |
the fixture with extreme care. Navigate the lamp all the |
| C |
| |
way until it reaches the reflector and the lamp base |
|
| ||
plate touches the bottom plate of the fixture. |
|
|
| |
7) Align the screw holes and fasten the screws back onto |
| Lamp plate |
| |
|
|
| ||
the lamp plate. |
|
|
|
8) Turn the fixture on and adjust the lamp alignment screws until the brightest most even area of the
beam is in the center of your spot. It may be necessary“Lampfor youAlignementto use a controllerHow ”insectionorder toin this
command the fixture to display a white beam. Visit the-To manual for further reading and tips on the subject.
9)Place the back cover plate back on the fixture and screw on securely.
6 |
