Chauvet ART-575W user manual Power, Am P Al Ig Nm Ent H Ow T O

C

Lamp Alignment Screws, A, B & C

Setup

L AM P AL IG NM ENT H OW - T O

Often, after a new installation of a lamp, you will find that there is an uneven field of light or what is referred to as a hot spot. This is due to the most intense point of the lamp source not being positioned optimally within the reflector.

There are three lamp alignment screws provided at the base of the projector head, behind the back cover plate. Turning these screws allow you to

optimize the projection quality of the spot as wellA B as the overall intensity of the beam.

1. Project a white flood against any flat surface.	D	E
Preferably the surface should be white or
pastel in color.

2.Turning the lamp alignment screws, try to position the hot spot in the center of the beam

as best as possible. This could require many attempts on your part.

3. Once the hot spot is in the center of the spot, do your best to turn all screws equally as to affect movement up or down within the reflector.

4.As you move in and out of optimum lamp focus, you will see the hot spot either gets wider or narrower. The goal is to either totally diminish the hot spot by having it widen and spread across the entire spot or moving the hot spot so that it covers as much of the beam spot area as possible.

Power

Warning! Verify that the internal multi-tap transformer is set to match the line voltage applied and that the proper fuse is installed for the appropriate voltage setting. All fixtures must be connected to circuits with a suitable Earth Ground.

CAUTION!

This lighting fixture comes from the factory with a 120V fuse pre- installed. To operate this fixture in 230V, please replace the external fuse with the supplied 230V fuse.

∙			To TRANSFORMER				LampControltoPCBin	ToBallast230V/60Hz	ToBallast230V/50Hz
	To determine the power requirements for
	a particular fixture, see the label affixed	AC-100-230V￿
	to the back plate of the fixture or refer to
		INPUT
∙	the fixture’s specifications chart.
	A fixture’s listed current rating is its
	average current draw under normal	IN	230V	208V 115V 100V			IN	60Hz 50Hz
∙	conditions.
	All fixtures must be powered directly off a
	switched circuit and cannot be run off a
	rheostat (variable resistor) or dimmer		230V	208V	115V	100V
	circuit, even if the rheostat or dimmer								60Hz
	channel is used solely for a 0% to 100%
∙	switch.								50Hz
	Before applying power to a fixture, check
	fixture’s requirement.
	that the source voltage matches the			Select volt age
∙
	All fixtures must be connected to circuits with a suitable Earth Ground.

POWER CABLE	PIN
BROWN	Live
BLUE	Neutral
YELLOW/GREEN	Earth

OPERATING VOLTAGE

120V

230V

INTERNATIONAL

L

N

EG (Ground)

MUST USE CORRECT FUSE

15A

10A

CAUTION!

Voltage selector switch is accessible by removing the front cover of the fixture. Re-wiring of the transformer should be conducted by a certified electrician or lighting professional.

ART-575W User Manual 7 2006-06-15/17:08