Setup
Mounting
Orientation
Rigging
Procedure
Product Mounting Diagram
Before mounting this fixture, read and follow the safety recommendations indicated in the Safety Notes section (page 2 of this manual).
Always mount this fixture in any safe position while making sure that there is adequate room around it for ventilation, configuration, and maintenance.
Make sure to mount this fixture away from any flammable material as indicated in the Safety Notes section.
The COLORado™ 1 IP consists of a sealed (IP66) housing with a double bracket mounting yoke. It has two DMX signal cables (DMX In/DMX Out), and two power cables (Power In/Power Out), all of them fitted with proprietary IP66 connectors.
CHAUVET® recommends following the general guidelines below when mounting the COLORado™ 1 IP.
•When selecting an installation location, consider ease of access to the fixture for operation, programming adjustments, and routine maintenance.
•If hanging this fixture, make sure that the location where you are mounting the fixture can support its weight. Please see the Technical Specifications section of this manual for the weight requirement of this fixture.
The COLORado™ 1 IP includes a safety cable and a mounting yoke to which you can attach one or two rigging clamps. You must supply your own “C” or “O” clamps and make sure that they are capable of supporting the weight of this fixture. Although it is possible to use a single clamp per fixture, CHAUVET® recommends using two clamps per fixture. Secure the fixture with the safety cable after mounting it to the truss.
C clamp(not included).
Floor Mounting
Secure the safety cable using the passageway on the back of the fixture.
Overhead Mounting
COLORado™ 1 IP User Manual Rev. 01c |
