Chauvet DVM-HR user manual Hardware Setup, AC Power, System Limitations, Power Cable Configuration

3. Hardware Setup

	AC Power
Warning!	Verify that the power requirement label on your unit matches the line voltage
	applied. All fixtures must be connected to circuits with a suitable Earth Ground.
	• To determine the power requirements for a particular fixture, see the label affixed to the back plate
	of the fixture or refer to the fixture’s specifications chart.
	• A fixture’s listed current rating is its average current draw under normal conditions.
	• All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
	(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
	to 100% switch.
	• Before applying power to a fixture, check that the source voltage matches the fixture’s
	requirement.
	• All fixtures must be connected to circuits with a suitable Earth Ground.

Power Cable Configuration

CABLE	Pin	International	Screw Color
BROWN	Live	L	Yellow or Brass
BLUE	Neutral	N	Silver
YELLOW/GREEN	Earth	EG (Ground)	Green
System Limitations
VERTICAL PANELS (DOWN)
MINIMUM		1 panel = 16 rows of LED clusters or 16 vertical pixels/lines
MAXIMUM WITH 1 DRIVER		16 panels = 256 rows of LED clusters or 256 vertical pixels/lines
MAXIMUM WITH 2+ DRIVERS		32 panels = 512 rows of LED clusters or 512 vertical pixels
HORIZONTAL PANELS (ACROSS)
MINIMUM		1 panel = 16 columns of LED clusters or 16 horizontal pixels/lines
MAXIMUM WITH 1 DRIVER		6 panels = 96 columns of LED clusters or 96 horizontal pixels/lines
MAXIMUM WITH 2+ DRIVERS		48 panels = 768 columns of LED clusters or 768 horizontal pixels
RESOLUTION
MINIMUM		16 pixels X 16 pixels
MAXIMUM WITH 1 DRIVER		96 pixels X 128 pixels
MAXIMUM WITH 2+ DRIVERS		768 pixels X 512 pixels

DV Wall System User Manual 7 2007-02-05/16:45