Chauvet f-95ww Power Linking , DMX Linking

Setup

OVATION™ F-95WW User Manual Rev. 2 -7-

Power Linking

The OVATION™ F-95WW supports po wer linking. You c an power link up to 15 units on

120 V; up to 25 units on 208 V; or up to 28 units on 230 V.

This product comes with a Neutrik® powerCON® input power

cord. This product does not

come with a power linking cable; however, a power linking ca bl e i s av ail abl e as an opti on .

DMX Linking

You can link the OVATION™ F-95WW to a DMX controller using a stand ard DM X serial

connection. If using other DMX-compatible products with the OVATION™ F-95WW

, you

can control each individually with a single DMX controller.

The OVATION™ F-95W W uses the standard DMX data connection for the 1-, 2- and

3-channel DMX modes.

· Refer to the Introduction chapter for a brief description of these modes.

· Refer to the Operation chapter to learn how to configure the OVATION™ F-95WW to

work in these modes.

· The DMX Values section provides you with detailed information regarding the DM X

modes.

The Master/Slave mode allows a single OVATION™ F-95W W (the “master”) to control

the actions of one or more OVATION™ F-95WW units (the “slaves”) without

the need of

a DMX controller to control the slaves. Once set and connected, the slaves

will operate

in unison with the master. For instructions on

connecting and configuring this product,

see Master/Slave Mode.

DO NOT connect a DMX controller to products operating in Slave mode. The DMX

controller signals may interfere with the signals from the master product.

The Operation section of this manual provides detailed instructions on how to

configure the master and slaves.

If you are not familiar with or need more information about DMX standards,

master/slave connectivity, or th

e DMX cables needed to link this product to a DMX

controller, download the DMX Primer

from the CHAUVET® website: