Setup, Lamp Installation | Chauvet Model ST-200 manual

SETUP

	The xenon 200 watt lamp comes pre-installed from the factory.
Warning!	When replacing the lamp, please wait 15 minutes after powering down to allow the
	unit to cool down! Always disconnect from main power prior to lamp replacement.
	Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
	with alcohol and wipe it with a lint free cloth before installation.

1)	Unscrew the three most left and right screws on the back of the ST-200X and lift the front cover
	carefully. The segment display can remain attached to the PCB during lamp replacement.
2)	Unscrew the three lamp wires from their respective terminals on the PCB as illustrated in Figure
	3. You may need to clip the tie-wraps that restrain the loose wires to the screw posts on the PCB
	in order to free the lamp.
3)	Slide lamp socket out of the thin metal plate one end at a time.
4)	Replace strobe with new lamp and re-fasten wires to the terminals. (CHAUVET lamp model #
	BL-200ST)
	ST-200 Lamp Installation	Top view

Lamp side with 1 wire molded into ceramic base gets fastened to terminal labeled J3.

Lamp side with 2 wires;

1. Wire molded into ceramic base is fastened to terminal labeled J4

2. Wire coiled around the envelope of the bulb gets fastened to terminal labeled J5.

ST-200 User Manual

Revision: 2004-11-02/11:23