Chauvet ST-3000LED user manual DMX Control Mode, Daisy Chain Serial Data Link

Operating Instructions

DMX CONTROL MODE

The ST-3000LED can be operated from a DMX controller. This control mode environment gives the user the greatest flexibility when it comes to customizing or creating a show by enabling the control of each individual trait of the fixture and each fixture independently.

Configuring for DMX control

1.Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.

2.Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector.

3.Then, proceed to connect from the DMX output as stated above to the DMX input of the following fixture and so on.

4.If you need help setting the DMX address read the section titled “Setting the DMX address” in this

Chapter.

Setting the DMX address

Each fixture requires a "start address" from 1 to 511. A fixture requiring one or more channels for control begins to read the data on the channel indicated by the start address. For example, a fixture that occupies or uses 7 channels of DMX and was addressed to start on DMX channel 100, would read data from channels: 100, 101, 102, 103, 104, 105 and 106. Choose start addresses so that the channels used do not overlap and notate the start address selected for future reference. If this is your first time, read the DMX Primer in the Appendix Section.

DAISY CHAIN (SERIAL DATA LINK)

DMX Output DMX Input

DMX:001

DMX:004

Use certified DMX XLR cable

DMX:007

1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10

1 2 3 4 5 6 7 8 9 10

Visit the section titled; Binary & DMX DIP Switch Addressing on page 13 & Binary Addressing Quick Reference Chart on page 14 to quickly determine the binary DIP-switch settings for addressing.

ST-3000LED User Manual 11 2009-12-10/14:04