SETUP
Lamp
| You will need to install a lamp prior to the initial operation of the fixture. A bulb is included with your |
| product. |
Warning! | When replacing the lamp, please wait 15 minutes after powering down to allow the |
| unit to cool down! Always disconnect from main power prior to lamp replacement. |
| Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp |
| with alcohol and wipe it with a lint free cloth before installation. |
LAMP INSTALLATION
1)Remove both thumbscrews located on the front of the fixture and open the lamp cover.
2)If replacing the lamp, remove old lamp first by unscrewing it from its base.
3)Hold the new lamp with a
4)Close lamp cover, align the screw holes and fasten the thumbscrews back onto the cover.
Figure 2 –
Remove both thumbscrews
Power
| Your product is equipped with | Slide switch up or down depending |
| setting and frequency. | |
| on your line voltage. | |
Warning! | Verify that the power select switch on your unit |
|
| matches the line voltage applied. All fixtures must |
|
| be connected to circuits with a suitable Earth |
|
| Ground. |
|
•To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart.
•A fixture’s listed current rating is its average current draw under normal conditions.
•All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
•Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.
•All fixtures must be connected to circuits with a suitable Earth Ground.
•When in doubt, please consult a qualified electrician to determine the frequency in your locale.
5 | Revision: |
