3.Depress the Stop Pin (3). Using the Wrench (49), Tighten the Flange Nut (47) by turning it clockwise until firmly in place. See Figure 1 below.
4.Wrap a clean Polishing Bonnet (48) on top of the Backing Pad (46). Tie it se- curely using the drawstring. Make sure to tuck any excess string inside the Bon- net. See Figure 2 below.
5.For sanding, place a sanding disk with a hole in the center onto the Backing Pad and secure it with the Flange Nut (47). See Figure 1 below.
Figure 1
Flange Nut (47)
Backing Pad (46 )
Output Shaft (42)
Stop Pin (3)
Side Handle (34) | Housing (16) |
Figure 2
Polishing Bonnet (48)
SKU 41213 | For technical questions, please call | Page 12 |
