product, but must be supplied by the operator.
Additional Safety Warnings for the Powder Coating System
1.The powder dust is flammable when floating in the air.
-Ventilate the area well.
-Verify that there are no flames or ignition source nearby.
-Control excess dust by cleaning up after each use.
-Never vacuum up the dust using a
-Never cure coated object in a gas oven as the fumes recreated can be flammable; only use an electric oven.
-Never smoke while using the Pow- der Coating System.
2.Avoid electrical shock!
-Never touch the emitter (metal tip) of the Spray Gun. After use (and turned OFF), touch the emitter to the Ground Clip to discharge it.
-Do not use the Spray Gun if you carry and use any electronic medical devices.
-Never touch the metal object during coating.
3.Avoid powder contamination.
-Protect your lungs by using an ap- proved dust mask.
-Never cure objects in an electric oven that is used for food also.
-Ventilate the area well.
-Wear an activated charcoal respi- rator when oven curing the coated object.
Unpacking
When unpacking, check to make sure the following parts are included (Refer to the Parts List and Assembly Drawing at the end of this manual):
- Spray Gun, | - Foot Switch, |
- Transformer, | - |
- two Powder Cups | - Ground Clip Cable |
- three Scatter Tips |
|
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
SKU 42802 | For technical questions, please call | Page 4 |
