Page 10SKU 44677 For technical questions, please call 1-800-444-3353.
Basic Function Instructions

Refer to the diagram on page 9 for these instructions:

1. Attach the Hose to the Hose Fixture of the Main Housing, by pressing it in and turning to tighten.
2. Attach the Hose to the Spray Gun by inserting the Hose into the fitting, and turning it to tighten.
3. Thin the paint according to the manufacturer’s instructions. Pour the paint mixture through a cheese
cloth or paint strainer into the Spray Gun.
4. Press the Switch to the ON position.
5. Point the Spray Gun where desired, and squeeze the Spray Gun Trigger to begin painting.
6. Release the Spray Gun Trigger to stop painting.
7. Move the Switch on the Main Housing to the OFF position to turn off the compressor.
Maintenance

After each use, thoroughly clean the spray gun.

1. Empty the Paint Cup of paint, and wipe it out with a clean rag.
2. Fill the Paint Cup about half way with the solvent which is appropriate for the paint you have sprayed.
3. Spray the solvent into an appropriate receptacle for proper disposal. Continue to spray until paint in
the interior of the Spray Gun is ejected and the solvent spray is clear.
NOTE: Always clean your sprayer immediately after use to avoid having to disassemble the Needle Valve
or Trigger assemblies. It is not recommended that you disassemble the paint sprayer.
4. Using a clean rag wetted with solvent, wipe off the Spray Gun to remove paint from the exterior.
5. Store your paint sprayer in a clean dry place out of the reach of children.
6. All servicing of the Electric Spray Gun Kit must be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF
ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY P ARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
REV 08/05
3. Remove the Fluid Adjusting Screw (4), along with the Spring (3) and Fluid Needle (7) underneath it.
Insert the desired Fluid Needle (7), and reinsert the Spring (3) and the Fluid Adjusting Screw (4).
4. Assemble the matching Fluid Tip (7), Air Cap (8), and Lock Ring (9).
5. The sprayer controls will require readjustment after this procedure is complete. See page 9.