Unpacking
When unpacking, check to make sure the following parts are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Inverter Unit
Battery Clamp
Cable
Lighter Output
Connector Cable
Operation
For the power inverter to work properly, your power source must provide between 10 to 15 volts DC, and the power source must provide enough current (i.e., 33 amps to operate the load of 400 Watts or under).
Caution: This inverter must only be connected to batteries with a nominal out- put voltage of 12 volts. Lower voltage will not operate the inverter properly, and more voltage could damage it. Do not use this inverter with positive ground electrical systems.
1.Place the Power Inverter on a flat surface. Make sure it
has adequate ventilation and is not in direct sunlight. | Red |
|
2.Connect either the lighter output connector cable or the battery clamp cable lugs to the red and black terminal screws on the back of the inverter. Securely tighten.
3. The Power Inverter can be used either while the engine is Black running or off. Insert the Lighter Output Connector Cable
plug firmly into the cigarette lighter socket. Or, connect the Battery Cable Clamps to the negative (black) and Positive (red) terminals of the battery.
4.Plug the 110 VAC device(s) you wish to power into the
SKU 47641 | Page 5 |
