28.Only the Inner Pot may be heated inside a microwave oven or roast oven.
29.Do not heat the Inner Pot when it is empty.
30.High humidity, altitude, and minor fluctuations in electrical power may slightly affect cooking times in the Slow Cooker.
31.Do not use abrasive cleansers when cleaning the Slow Cooker.
32.
WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.
33.
WARNING! The warnings and cautions discussed in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS
GROUNDING
WARNING!
Improperly connecting the grounding wire can result in the risk of electric shock. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify the power cord plug provided with the appliance. Never remove the grounding prong from the plug. Do not use the appliance if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician.
GROUNDED APPLIANCES: APPLIANCES WITH THREE PRONG PLUGS
1.Appliances marked with “Grounding Required” have a three wire cord and three prong grounding plug. The plug must be connected to a properly grounded outlet. If the appliance should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user, reducing the risk of electric shock. (See Figure A.)
2.The grounding prong in the plug is connected through the green wire inside the cord to the grounding system in the appliance. The green wire in the cord must be the only wire connected to the appliance’s grounding system and must never be attached to an electrically “live” terminal. (See Figure A.)
