
SpecificationsASSEMBLY
Electrical Specifications | 120 V~ / 60 Hz / 10 A |
No load speed | 1000~3500 RPM |
Maximum Accessory Size | 7” Diameter |
Mounting Disc Type | 7” Hook & Loop |
Variable Speed Switch | Sliding Button (+ & |
Display Unit of Measure | RPM x 100 |
Accessories | Polishing Bonnet |
| Foam Bonnet |
| Sanding Disc - 80 Grit |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Instructions for putting
into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch (11) off and unplug the Polisher from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
AUXILIARY HANDLE (36)
Spindle
Lock (34)
GEAR BOX |
| FIGURE B | |
|
| ||
(32) |
|
|
|
MOUNTING |
|
| |
DISC (51) |
|
|
|
1.To attach the Mounting Disc (51) to the Polisher, press and hold the Spindle
Lock (34). Screw the Mounting Disc onto the Spindle (50) of the tool. Then release pressure on the Spindle Lock.
2.To attach the Auxiliary Handle (36), screw the Handle firmly into the threaded mounting hole located on either side of the Gear Box (32).
Page 10 | For technical questions, please call | SKU 66615 |