Chicago Electric 66615 To Polish An Object, See Figures a and B To Sand An Object

8. During the sanding process, it may be necessary to occasionally stop the Polisher, disconnect it from its electrical outlet, remove the worn sandpaper and replace with new sandpaper.

9. When the sanding process is complete, turn the Power Switch (11) to its “OFF” position. Then unplug the Power Cord

(5). (See Figure C.)

11.Allow sufficient time for the polishing liquid or wax to dry on the object.

To Polish An Object:

1.Attach the Polishing Bonnet (52) to the Mounting Disc (51) as previously discussed in this manual.

(See Figures A and B.)

2.Plug the Power Cord (5) into the nearest 120 volt, grounded, electrical outlet.

3.In order to keep the Power Cord (5) out of the way, hang it over your shoulder.

IMPORTANT: Start and stop the Polisher only while it is held firmly against the surface of the object being polished. Failure to do so may result in the Polishing Bonnet

(52) being thrown from the Mounting Disc (51).

4.Grip the Polisher firmly with both hands.

Then turn the Power Switch (11) to its “ON” position. (See Figure C.)

5.Increase the tool’s speed by pressing the + Speed Button (13). Decrease the tool’s speed by pressing the – Speed Button (13). (See Figure C.)

6.The Display (10) will indicate the tool’s speed.

7.Begin polishing the object by lightly buffing off the polishing liquid or wax residue in broad sweeping strokes in a figure eight pattern. Continue polishing until all the residue is removed.

IMPORTANT: Apply minimal pressure on the Polisher to avoid damaging the surface of the object.

9.Remove the Polishing Bonnet (52) from the Mounting Disc (51). With the Polishing Bonnet in your hand, remove the polishing liquid or wax from all hard to reach areas of the object.

(See Figures A and B.)

To Sand An Object:

1.Attach the Sanding Disc (54) to the Mounting Disc (51) as previously discussed in this manual.

(See Figures A and B.)

2.Plug the Power Cord (5) into the nearest 120 volt, grounded, electrical outlet.

3.In order to keep the Power Cord (5) out of the way, hang it over your shoulder.

4.Grip the Polisher firmly with both hands.

Then turn the Power Switch (11) to its “ON” position. (See Figure C.)

5.Increase the tool’s speed by pressing the + Speed Button (13). Decrease the tool’s speed by pressing the – Speed Button (13). (See Figure C.)

6.The Display (10) will indicate the tool’s speed.

7.Once the Sanding Disc (54) is turning at the desired speed, sand the object evenly with gentle, broad, sweeping strokes in a criss-cross pattern.

8.After the polishing liquid or wax has been removed from the object’s surface, slide the Power Switch (11) to its “OFF” position. Then unplug the Power Cord

(5). (See Figure C.)

SKU 66615 For technical questions, please call 1-800-444-3353. Page 13