Installing a Drill Bit
1.Remove the Battery Pack and slide Direction Switch (43) to its
2.While holding Drill/Driver and the Chuck sleeve (adjacent to the frame) in one hand, turn the Chuck (26) counterclockwise to open the jaws.
3.Insert the bit or a Hex
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Direction Switch (43) of the tool to its center neutral position and remove the Battery and any attachments before performing any inspection, maintenance, or cleaning procedures.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Secure loose work pieces using a vise or clamps (not included) to pre- vent movement while working.
3.There must not be hazardous ob- jects, such as utility lines or foreign objects, nearby that will present a hazard while working.
4.WARNING! Verify that the sur- face has no hidden utility lines before drilling or driving screws.
General Operating Instructions
1.Mark the position of the hole to be drilled with a center punch to prevent the Drill from “walking”.
2.Attach the Battery to the bottom of the handle, it will click when it locks into place. Please Note: The Bat- tery fits only in one position. Do not force the Pack when inserting.
3.Press the Direction Switch (43) to the desired position (Forward or Reverse). See the forward/reverse arrows on the sides of the Direction Switch.
4.When working with screws, turn the
Torque Selector to any one of the first
23 torque settings. Do not change the torque setting while the drill is moving. And always start from a lower setting to prevent unnecessary force.
5.When drilling a hole, set the Selector to the “Drill” icon. Pull the Trigger to start the Drill/Driver. Allow the drill to come up to full speed, before, apply- ing it to the work surface.
6.Hold the Drill firmly with both hands, as torque will cause the tool to twist.
7.When drilling through light gauge metal or thin, soft wood, place a wooden block behind the material to prevent burr or splinter damage when
SKU 67089 | For technical questions, please call | Page 7 |
