Page 13for technical questions, please call 1-800-444-3353.SKU 67707

troubleshooting

problem possible causes Likely Solutions

Tool will not start. Battery Pack needs charging1.
Battery Pack not properly seated. 2.
Connection to Battery Pack 3.
damaged.
Charge Battery Pack.1.
Check that Battery Pack is fully inserted into tool 2.
so that it snaps into place.
Check that the terminals inside the tool are not 3.
bent or missing. Have repaired by a qualiî‚żed
technician if needed.
Tool operates slowly. Battery Pack needs charging.1.
Job is for a more powerful tool.2.
Charge Battery Pack.1.
Use a stronger powered tool.2.
Performance
decreases over time.
Accessory dull or damaged.1. Keep cutting accessories sharp. Replace as 1.
needed. Replace sandpaper when it becomes
worn or torn.
Excessive noise or
rattling.
Internal damage or wear. Have technician service tool.
Overheating. Forcing tool to work too fast.1.
Accessory misaligned. 2.
Accessory dull or damaged. 3.
Blocked motor housing vents.4.
Allow tool to work at its own rate.1.
Check and correct accessory to fence and/or 2.
table alignment.
Keep cutting accessories sharp. Replace as 3.
needed. Replace sandpaper when it becomes
worn or torn.
Wear ANSI-approved safety goggles and NIOSH-4.
approved dust mask/respirator while blowing dust
out of motor using compressed air.

follow all safety precautions whenever diagnosing or servicing the tool.

disconnect power supply before service.

pLeaSe read the foLLoWing carefuLLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy
DIAgRAM IN THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS qUALIFIED TO MAkE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS qUALIFIED
TO REPLACE ANy PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAkEN By
CERTIFIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER. THE BUyER ASSUMES ALL RISk
AND LIABILITy ARISINg OUT OF HIS OR HER REPAIRS TO THE ORIgINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISINg OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.