Chicago Electric 69454 ASSEMBLY Installing the Wheel Guard

Page 12 For technical questions, please call 1-800-444-3353. Item 69454
Specifications
Electrical Rating 120V~ / 60Hz / 11A
Motor No Load Speed 7800 RPM
Max. Accessory Diameter 7″ (178 mm)
Max. Accessory Thickness 1/4" (6mm)
Arbor Hole Diameter 7/8"
Using included adapter
Spindle Thread 5/8″ x 11 TPI
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
ASSEMBLY
Installing the Wheel Guard
TO PREVENT SERIOUS INJURY: Do not operate this tool without the Wheel Guard properly installed.
Wheel
Guard
Nut
Gear
Housing
Wheel Guard
Collar
Figure A
1. Loosen the Wheel Guard Nut.
2. Slide the collar of the Wheel Guard
over the rim of the Gear Housing.
3. Rotate the Wheel Guard as needed to
shield you during the planned work.
4. Tighten the Wheel Guard Nut securely.
5. Check the Wheel Guard to ensure it is firmly in place.
Adjust if necessary before proceeding.
SAFETY OPERATION MAINTENANCESETUP