Specifications
Electrical Input | 120 V~ / 60 Hz / 7.5 A (Rated) |
Belt Speed | 1,250 FPM (No Load) |
Belt Size | 3” x 21” |
Accessories | Dust Bag / 120 Grit Belt |
| E194601 |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Assembly
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To Remove/Install A Sanding Belt:
Trigger
(66)
SANDING
BELT (46)
TENSION LEVER OF
Figure A FRONT WHEEL FRAME (53)
1.Pull out on the Tension Lever of the Front
Wheel Frame (53), and slide the Sanding Belt (46) out. (See Figure A.)
2.Slide a new Sanding Belt (46) on. Then, push in on the Tension Lever of the Front
Wheel Frame (53). (See Figure A.)
3.Plug the Power Cord (14) into the nearest 120 volt, grounded, electrical outlet.
CAUTION! The machined parts near the Tension Adjuster (29) may be sharp. Wear work gloves when adjusting the tension.
To prevent serious injury
from accidental operation:
Turn the Trigger of the tool off and unplug the tool from its electrical outlet before assembling or making any
Tension |
Adjuster |
(29) |
Figure B
SWITCH
LOCK
Trigger
(66)
LEFT |
HOUSING |
(18) |
adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
REV 04j; 09k
4.Grip the Belt Sander firmly with both hands. Lift the tool and squeeze the
Trigger (66). As the Sanding Belt (46) turns, observe the Sanding Belt to see if it is turning
Sanding Belt turns
SKU 90045 | For technical questions, please call | Page 9 |
