2.WARNING! When sanding a workpiece, always push and pull the Belt Sander over the workpiece with both hands firmly gripping the tool. Do not pass hands or fingers directly in front of, to the rear, or below the Sanding Belt (46).
3.Firmly grip the Belt Sander with both hands. Then, squeeze the Trigger (66) to turn on the tool. If desired, use the
Switch Lock to run the Belt Sander in its continuous mode.
4.Allow the Sanding Belt (46) to turn up to full speed before feeding the Sanding Belt into the workpiece.
5.To avoid damaging the workpiece, always sand parallel to the grain of the wood.
6.Do not force the Belt Sander to remove material faster than it is designed to cut. Push and pull the Sanding Belt
(46) gradually along the surface of the workpiece.
7.Once the sanding job is completed, turn off the Belt Sander and wait until the Sanding Belt (46) stops turning. To prevent accidents, make sure the trigger is released and disconnect the power supply after use. Clean, then store the tool indoors out of children’s reach.
SKU 90045 | For technical questions, please call | Page 11 |
