Tripp Lite APS512 Specifications, Frequency compatibility Output watts, Input, Battery

2 outlets; 6-ft. AC power cord; DC input terminals for 12V battery connection

Converts 12 volt DC to 120 volt AC

Frequency control for operating stability

Advanced 18 amp, 3-stage battery charger and selector switch for gel or wet cell batteries

Resettable circuit breaker protects APS against system overload

Switch allows user to select between off, auto-invert and charge-only settings

6 diagnostic LEDs indicate AC present, on battery, overload, & battery voltage level (high, medium, & low)

Configuration switches to allow the user to select the high and low voltage for the unit to automatically transfer from AC power to battery backup

Coated internal circuit boards offer continuous operation in humid environments (0-95%, non condensing)

3.5mm port for connecting remote switch (User supplies plug, cable and switch - see manual)

Allows unlimited runtime capability by allowing the use any number of user-supplied batteries

Specifications

OUTPUT

Frequency compatibility

Output watts

Output nominal voltage

Output voltage regulation

Output frequency regulation

Overload protection

Outlet quantity / type

INPUT

60 Hz

Continuous - 500 watts, Overpower (up to 1 hour) - 750 watts, Double-Boost wattage (up to 10 seconds) - 1000 watts

AC OUTPUT: 120V AC nominal, DC CHARGER OUTPUT (DC): 12V DC nominal

LINE POWER (AC): Maintains 120V nominal sine wave output. INVERTER POWER (AC): Maintains PWM sine wave output voltage of 120 VAC (+/-5%). DC CHARGER OUTPUT (See battery recharge rate section)

60 Hz (+/- 0.3 Hz)

Circuit breaker

Includes 2 AC outlets (NEMA 5-15R)

Recommended Electrical Service

Maximum input amps / watts

Input connection type

Voltage compatibility (VAC)

Voltage compatibility (VDC)

BATTERY

DC INPUT: Requires 12V DC input source capable of delivering 50A for the required duration (when used at full continuous capacity). For automotive applications, professional hardwire installation with 100A battery system fusing is recommended. AC INPUT

DC INPUT: Full continuous load - 50A at 12VDC, No load - 2.2A at 12V DC. AC INPUT: 8 amps at 120V AC with full inverter and charger load

DC INPUT: Set of 2 DC input wingnut terminals. AC INPUT: NEMA 5-15P input plug

120

12

Expandable battery runtime

DC system voltage (VDC)

Battery Pack Accessory (optional)

Runtime is expandable with any number of user supplied wet or gel type batteries

15

98-121sealed lead acid battery (optional)

Battery recharge rate

Includes 20 amp DC charging system

LEDS ALARMS & SWITCHES

Switches

Lighted on/off power switch, plus 2 conductor 3.5 mm port for connecting remote switch - user supplies switch, 3.5mm plug and cable.