OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 18.
Pre-Start Checks:
1.NOTE: During operation, it may be necessary to refer to the Engine manufacturer’s Operation, Maintenance, and Parts manual (included) for detailed information about starting, running, and stopping the Engine.
2.Check to make sure the Engine’s “ON/OFF” Switch is in its “OFF” position.
3.Unscrew and remove the Engine’s Oil Fill Cap located at the bottom of the En- gine Crankcase. Check to make sure the oil level is even with the top of the Oil Fill Hole. If necessary, add oil until its level is even with the Oil Fill Hole. Then, screw the Oil Fill Cap back into the Oil Fill Hole. NOTE: Check with the Engine manufacturer’s manual for the proper type of engine oil required for use.
(See Figure C.)
4.Check the Fuel Gauge (34) for the amount of unleaded gasoline in the Fuel Tank (32). If necessary, remove the Fuel Tank Cap (37) and refill the Fuel Tank with unleaded gasoline. Then, replace the Fuel Tank Cap.
(See Figure D.)
FUEL TANK CAP (37) FUEL GAUGE (34)
FUELTANK (32)
OIL FILL CAP
FIGURE C
FIGURE D
REV 11/04
SKU 90236 | For technical questions, please call | Page 13 |
