Chicago Electric 90236 manual To Start The Generator, See Figure E, See Figure F, Figure G

To Start The Generator:

1.Turn the Fuel Valve (31) to its vertical “OPEN” position.

(See Figure E.)

2.Move the Engine’s Fuel Choke all the way to the right to its “START” posi- tion. (See Figure E.)

3.Turn the Engine’s “ON/OFF” Switch

(46) to its “ON” position

(See Figure F.)

4.Grasp the Handle of the Engine’s Starter Pulley and rapidly pull the Starter Pulley to start the Engine. NOTE: It may take more than one pull on the Starter Pulley to start the En- gine.

5.Allow the Engine to run for several seconds, then move the Engine’s Fuel Choke all the way to the left to its “RUN” position. (See Figure E.)

NOTE: DO NOT ATTEMPT TO ADJUST THE ENGINE’S THROTTLE! This engine uses a governor device to automatically control the engine’s speed. If the throttle is adjusted, it may result in decreased efficiency and/or damage to the unit.

CHOKE

FUEL VALVE (31)

Hidden from view

FIGURE E

ON/OFF

Switch

FIGURE F

OVERLOAD BREAKERS	120V DUAL OUTLET	120/240 V
		TWISTLOCK OUTLET	GROUNDING POINT
(42)	(43)
		(44)
FIGURE G
			REV 06/04; 11/04

SKU 90236 For technical questions, please call 1-800-444-3353. Page 14