Saw Blade (6) from the Spindle of the Wet Tile Saw. Then, install a new diamond Saw Blade with a 7” diameter, 5/8” round arbor hole, and rated at a minimum 3,600 RPM. (See Figure D.)
6.NOTE: When installing the new Saw Blade (6), make sure the directional arrow shown on the Saw Blade is pointing toward the front of the Wet Tile Saw.
(See Figure D.)
7Replace the Outer Washer (28). Then, firmly tighten the Blade Lock Nut (27) counterclockwise to secure the Saw Blade (6) in place. (See Figure D.)
|
|
|
|
|
|
|
| WING NUT | ||
|
|
|
|
|
|
|
| |||
|
|
| (3) | |||||||
WING NUT SCREW |
|
|
|
|
|
|
|
| BLADE GUARD | |
|
|
|
|
|
|
|
| |||
(1) |
|
| (2) | |||||||
GUARD SUPPORT |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |||
(4) |
|
|
|
|
|
|
|
|
|
|
GUARD SUPPORT SCREW |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| ||
(5) |
|
|
|
|
|
|
|
|
|
|
SAW BLADE |
|
|
|
|
|
|
|
| ||
(6) |
|
|
|
|
|
|
|
|
|
|
OUTER WASHER
(28)
BLADE LOCK NUT
(27)
LEFT CUTTING TABLE
(26)
FIGURE D
To Attach The Saw Blade Guard:
1.Align the mounting hole in the Guard Support (4) with the mounting hole in the inner edge of the frame of the Wet Tile Saw. Then secure the Guard Support to the frame, using one Guard Support Screw (5). (See Figure D.)
2.Secure the Blade Guard (2) to the top portion of the Guard Support (4), using one Wing Nut Screw (1) and one Wing Nut (3). (See Figure D.)
SKU 91511 | PAGE 11 |
