Lincoln Electric IM827-D manual LINC-NET System Error Codes

E-8	TROUbLESHOOTING	E-8
	Observe all Safety Guidelines detailed throughout this manual

PRObLEMS

(SYMPTOMS)

POSSIbLE

CAUSE

RECOMMENDED

COURSE OF ACTION

	LINC-NET SYSTEM ERROR CODES
Err 006		1. The wire feeder has not received
			a recognition command from the
			power source. Verify the power
			source is operating properly
			(Status light steady green.)
		2.	Check control cable for loose or
			broken leads.
		3.	See power source service
			Manual.
Err 100		1. The power source has issued a
			shutdown command. Verify the
			power source is operating proper-
			ly. (Status light steady green.)
		2.	Check control cable for loose or
			broken leads.
		3.	See power source service
			Manual.
	ARCLINK SYSTEM	ERROR CODES
Err 31	Primary overcurrent	1. The power source has exceeded
			input current limits. Adjust the
			welding procedure to reduce the
			current draw. The welding proce-
			dure may exceed the capacity of
			the power source.
		2.	See the power source service
			Manual.
Err 32	Capacitor bank "A" under	1. The power source input power
	voltage.		may be wired incorrectly. Verify
			the power source reconnect
			panel wiring matches the input
			power.
		2. See the power source service
			Manual.

Check to see if the STATUS LED on the Power Wave 455 is not steady green. If it is not steady green, refer to the Power Wave 455 Status LED Chart and Code Table. Check the control cables for loose or faulty con- nections. Also check the continuity of all five leads from one end to the other. The control board in the PW 455 may be faulty.

See Err 006 in this chart.

CAUTION

If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.

POWER FEED™ 10M SINGLE WIRE FEEDER