INSTALLATION | ||
|
|
|
SAFETY PRECAUTION
ELECTRIC SHOCK can kill.
•Only qualified personnel should perform this installation.
•Turn off the input power to the power source at the disconnect switch or fuse box before working on this equipment. Turn off the input power to any other equipment connected to the welding system at the disconnect switch or fuse box before working on this equipment.
•Do not touch electrically hot parts.
LOCATION
•The Power Feed™ 10M Single Wire Feeder has an IP21 rating, suitable for indoor use.
•The Power Feed™ 10M Single Wire Feeder should be operated in a substantially upright position.
•Do not submerge the Power Feed™ 10M Single Wire Feeder.
•The Power Feed™ 10M Single Wire Feeder is not suitable for stacking.
Locate the Power Feed™ 10M Single Wire Feeder away from radio controlled machinery. The normal operation of the Power Feed™ 10M Single Wire Feeder may adversely affect the operation of RF con- trolled equipment, which may result in bodily injury or damage to the equipment.
FIGURE A.1
MOUNTING
Wire Drive Mounting (See Figure A.1)
The wire drive may be mounted by using the four holes on the bottom. Because the feed plate and gearbox are electrically "hot" when welding, make cer- tain the parts do not contact the any structure or per- son.
Mount the wire drive with the drive rolls in the vertical plane to prevent dirt from collecting in the wire drive. Angle the drive and feed plate to prevent sharp bends in the gun and cable and incoming wire.
Control box Mounting (See Figure A.2)
Boom model Power Feed™ 10M Single Wire Feeder's feature a control box that mounts separately from the wire drive.
The back of the control box has four keyhole slots for mounting. #10 screws are recommended for mount- ing.
