INSTALLATION | ||
|
|
|
CLAMPING COLLAR SCREWS
LOW SPEED SCREW SETTING
HIGH SPEED SCREW SETTING
SCREW FOR ROTATING
FEED PLATE
9.Loosen the two screws on the bottom of the feed plate clamping collar.
10.Rotate the feed plate to the desired position.
11.Tighten the two screws on the bottom of the feed plate clamping collar.
FIGURE A.7
| DIP Switch #8 Position |
|
| Gear Ratio |
|
| ON |
|
| High speed |
|
| OFF |
|
| Low speed (default) |
|
|
|
|
|
|
|
12.Remove the rear access panel on the wire drive.
13.Locate DIP switches on the Wire Drive Board.
14.Set DIP switch #8 to the desired polarity.
15.Reinstall the rear access panel to the wire drive.
16.Restore power.
WIRE REEL LOADING
Spindle Placement
The wire reel stand provides two mounting locations for the spindle. Each mounting location consists of a tube in the center of the mast and locating slots.
Loading 16 to 44 lb. (7.3 – 20kg) Spools
1.Squeeze the release bar on the retaining collar and remove it from the spindle.
2.Place the spool on the spindle, aligning the spindle brake pin with one of the holes in the back side of the spool. An indicator mark on the end of the spin- dle shows the orientation of the brake holding pin. Be certain the wire feeds off of the spool in the proper direction.
3.
Loading 10 to 15 lb. (4.5 – 6.8kg) Spools
A K419 spindle adapter is required for loading 2" wide spools on 2" (51mm) spindles. Use a
1.Squeeze the release bar on the retaining collar and remove it from the spindle.
2.Place the spindle adapter on the spindle, aligning the spindle brake pin with the hole in the adapter.
3.Place the spool on the spindle and align the adapter brake tab with one of the holes in the back side of the spool. An indicator mark on the end of the spindle shows the orientation of the brake tab. Be certain the wire feeds off of the spool in the proper direction.
4.
