10.Warning: Locate Trelllis in a spot that is flat without an uneven surface, away from
electrical wires. Caution: Heavy winds could make the Trellis unstable.
11.Always distribute objects on Bench evenly. Uneven weight distribution could cause toppling. Do not allow children to climb on the Trellis.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the following parts are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Assembly Instructions
1.Assemble all parts on a smooth surface to avoid scratching. These parts fit together and no hardware is required.
2.“Ladder”Assembly: Use Cross Beams (2) and Bars (3) to form “ladder”. Set aside. See Figure A.
3.“Side Lattice” Assembly: Use four Bars (4) (horizontally), three Bars (5) (vertically) with two Bars (11) (horizontally) at the top and bottom to build the “lattice” assembly. Repeat instructions for the second side “lattice”.
See Figure B.
4.Still working with the parts on the ground, fit the Support Bar (7) between the Posts (6). Fit the side “lattice” assembly between the two Posts (6). Repeat for second side, “lattice” with Posts. Be sure all connections are secure.
See Figure B.
| Cross | Post (6) | |
Bars (3) | Bars (4) | ||
Beams (2) | |||
| (horizontal) | ||
|
| ||
|
| Bars (5) | |
|
| ||
|
| (vertical) | |
|
| Bars (11) | |
|
| (horizontal) | |
|
| Support Bar | |
|
| (7) | |
|
|
Figure A
Bars (11)
(horizontal)
