Chicago Electric 91761 manual See Figure C, Figure D

5.Choose your location: The location site should be a flat, even surface (three possible set-up options: 1.) The Trellis can be free standing but caution should be taken: Always distribute weight evenly on the bench to prevent toppling. 2.) Stand the Trellis upright and place in 6” deep holes. Test that the Trellis is level. Pack dirt around Posts (6). 3.) Place cement in the holes before positioning the Posts (6). Test that the Trellis is level. If you are not experienced in setting up this type of product, it is recommended that you seek the assistance of a qualified handyman for placement of your Trellis.

6.Place the assembled sides of the Trellis flat on the ground nearest to the location. With an assistant, insert the “ladder assembly” into the Posts (6).

See Figure C.

Gothic Cap (1)

Post (6)

Clamps

Metal

Bars

Figure D

Ladder

Assembly

Figure C

Support

Bar (7)

Figure E Figure F

Bench (8)

7.There must be metal bars inserted in the two Braces (8) to support the weight placed on the Bench (8). See Figure D. Snap the Bench (8) over the Support Bar (7). See Figure F–G.

8.Tap the Gothic Caps (1) on the end of each Post (6). See Figure C.

SKU 91761 For technical questions, please call 1-800-444-3353. Page 4