OPERATING INSTRUCTIONS
1.Use caution when drilling into existing walls or other blind areas. Check for unexposed electrical wires and cables in the drilling path before drilling.
2.Use the Forward/Reverse Switch (35) to select the desired rotation of the tool.
(See Figure D.)
3.Insert a drill bit (not included) into the Drill Chuck (3), and secure the drill bit in the Drill Chuck with the Chuck Key (33). (See Figure D.)
4.Make sure the Trigger (30) is in its “OFF” position. Then, plug the Power Cord/ Plug (31) into the nearest 120 volt, grounded, electrical outlet. (See Figure D.)
5.Before drilling, clamp the object down securely. A poorly secured piece of material may result in personal injury and/or innacurate drilling.
6.Mark the center of the hole to be drilled with a center punch to prevent the drill bit from “walking” when first beginning to drill.
7.Hold the Drill firmly with both hands.
8.Position the drill bit on the material that is to be drilled.
9.To begin drilling, squeeze the Trigger (30). The speed at which the Drill Chuck
(3) rotates varies depending on how far in the Trigger is squeezed.
(See Figure D.)
10.If desired, activate the Trigger Lock (34) to set the Drill in a continuous run mode.
(See Figure D.)
11.Avoid overloading the Drill. Do not apply excessive pressure to the Drill while drilling. If the speed of the tool drops abnormally, decrease the pressure immediately. If the drill bit stops abruptly, or the drill bit becomes blocked, release the Trigger (30) at once. (See Figure D.)
12.Drill only as deep as is necessary. Do not drill deeper than necessary into walls or other areas where you cannot identify any possible hazards behind the drilling surface.
13.To reduce jamming as the drill bit breaks through the workpiece, decrease the drilling pressure when the point of the drill bit breaks through the workpiece.
SKU 92956 | For technical questions please call | PAGE 11 |
