UNPACKING
When unpacking, check to make sure all accessories listed above are included, and that the product is intact and undamaged
PRODUCT FEATURES
NOTE:
For additional information regarding the parts mentioned in
the following pages, refer to the Assembly Diagram on page 14.
1.Drill Chuck (3) and Chuck Key (33): The Close Quarter Drill is equipped with a 3/8” keyed Drill Chuck (3) that will accept drill bits (not included) with a 1/16” to 3/8” shank. Installing a drill bit into the Drill Chuck requires the use of the accessory Chuck Key (33). Always make sure the drill bits are firmly secured in the Drill Chuck prior to using the Drill. (See Figure D.)
2.Trigger (30) and Trigger Lock (34): The Trigger (30) is operated manually simply by squeezing the Trigger to turn on the Drill and releasing pressure on the Trigger to turn off the Drill. The Trigger features a Trigger Lock (34) for continuous running of the Drill. To set the Drill in a continuous run mode, squeeze the Trigger and depress the Trigger Lock. Then, release pressure on the Trigger.
The Drill will continue to run. To turn off the Drill, squeeze and let up on the Trigger. (See Figure D.)
3.Forward/Reverse Switch (35): The Forward/Reverse Switch (35) is located directly above the Trigger (30). For clockwise rotation, move the Forward/ Reverse Switch to the right. For a counterclockwise rotation, move the Forward/Reverse Switch to the left. Use the Forward/Reverse Switch only after the Hammer Drill has come to a complete stop. (See Figure D.)
DRILL CHUCK (3) |
|
FORWARD/REVERSE SWITCH (35) |
|
TRIGGER (30) | TRIGGER LOCK (34) |
CHUCK KEY
(33)
TO LOOSEN
TO TIGHTEN
POWER CORD/PLUG | FIGURE D |
| |
(31) |
|
SKU 92956 | For technical questions please call | PAGE 10 |
