14.When you have drilled the hole, remove the drill bit from the hole while the Drill Chuck (3) is still rotating. This prevents the drill bit from getting caught in the hole and causing damage.
15.Release pressure on the Trigger (30) to stop the Drill. (See Figure D.)
16.Unplug the Drill from its electrical outlet.
17.Remove the drill bit from the Drill Chuck (3). Then, store the Drill and its Chuck Key (33) in a dry, safe, location out of reach of children and other unauthorized users.
INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Always make sure the Trigger (30) is in its “OFF” position, and unplug the Power Cord/Plug (31) from its 120 volt electrical outlet before performing any inspection, adjustments, maintenance, or cleaning.
2.Before each use, inspect the general condition of the Drill. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, loose, cracked, or bent drill bits, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.Daily: With a soft brush, cloth, or vacuum, remove all dust and debris from the Drill. Then, use a premium quality, lightweight machine oil to lubricate
all external moving parts.
4.To replace the Carbon Brushes: It may become necessary at sometime to replace the two Carbon Brushes (19) when the Motor performance decreases, or stops working completely. The Carbon Brushes are located on each side of the Motor Housing (4) and Motor Housing Cover (17). To do so, remove the two Brush Holder Covers (18). Then, remove the two Carbon Brushes from the Brush Holders (20). If the Carbon Brushes are worn down more than 1/2, replace both Carbon Brushes. If, however, the Carbon Brushes are just dirty they may be cleaned by rubbing them with a pencil eraser. When installing the Carbon Brushes, make sure the carbon portion of the Carbon Brushes contact the Motor Armature, and that the springs face away from the Motor. Also, make sure the springs operate freely. After cleaning or replacement, replace the Brush Holders. NOTE: New Carbon Brushes tend to arc or spark when first used until they wear and conform to the Motor’s Armature. (See Figure E, next page.)
SKU 92956 For technical questions please call
