Attaching Sandpaper to the Backing Pad
Switch (15)
Backing
Pad (23)
The Sanding Disc is attached by Hook and Loop to the Backing Pad. Place the Sanding Disc on the Backing Pad lining up the 8 holes so that the dust can be collected into the Dust Bag.
approved eye and hearing protection, as well as heavy work gloves.
6.Before beginning work, provide for sparks and debris that will fly off the work surface.
General Operating Instructions
1.Turn on the Sander using the Switch.
2.Run the Sander for a few seconds before contacting the workpiece.
3.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working. Make sure the wood you are sanding does not have any nails or metal of any kind in it, or you will ruin the sandpaper and damage the Backing Pad.
5.You must use personal safety equipment including, but not limited to, ANSI-
Note: All orbital sanders leave sanding marks on the workpiece. To minimize sanding marks, always try to sand with the grain of the wood.
4.Occasionally check the sandpaper for tears, wear, or fraying. Replace if necessary.
5.When you are finished, turn off the
Switch.
6.Allow the tool to come to a complete stop before setting it down.
7.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool indoors out of children’s reach.
SKU 93431 | For technical questions, please call | Page 11 |