SAFETYWARNINGS AND PRECAUTIONS
1.
WARNING! Avoid risk of fire. Prior to installation remove the cables from the negative terminals of all the batteries on your vehicle.
2.Inhalation Hazard! Do not operate an engine in a closed area or in a poorly ventilated area. When running, an engine produces carbon monoxide, a colorless, odorless, toxic fume that, when inhaled, can cause serious personal injury or death.
3.Prior to installation, make sure to read and understand all instructions and safety precautions as outlined in the engine manufacturer’s diagnostic/repair manual.
4.Prior to installation, make sure the vehicle’s transmission is placed in “PARK” or “NEUTRAL” and the emergency brake is applied.
5.Always keep hands, fingers, and body away from the moving parts and hot parts of the engine.
6.Dress properly. Do not wear loose clothing or jewelry as they can be caught up in moving parts. Wear restrictive hair covering to contain long hair.
7.Do not use this product if under the influence of alcohol or drugs. Read warning labels if taking prescription medicine to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not use this product.
8.Replacement parts and accessories: This product must be repaired and serviced by a qualified service technician only. When this product is serviced, only identical replacement parts should be used. Use of any other parts will void the warranty. Only use accessories intended for use with this product.
9.WARNING! Avoid eye injury. Make sure to wear
10.
WARNING! The warnings and cautions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
REQUIREDTOOLS AND HARDWARE
1.Prior to installation, make sure you have the following tools and hardware (all not included) to complete the installation:
A. Phillips screwdriver | F. Automotive Grade Wire |
B. Drill with 1/8” bit | G. Ring Terminals |
C. Wire crimper | H. Butt Connectors |
D. Open end wrench set | I. Appropriately sized circuit breaker |
E. Nut driver set | J. Terminal boot covers |
SKU 93801/93802 For technical questions, please call
