6.Connect the Generator only to a load or electrical system (120 volt) that is compatible with the electrical characteristics and rated capacities of the Generator.
7.Be sure the Power Switch (14) is in its “OFF” position before moving the Generator and before performing any service, maintenance, or cleaning procedures on the unit.
8.Keep all electrical equipment clean and dry. Replace any wiring where the insulation is cracked, cut, abraded, or otherwise degraded. Replace terminals that are worn, discolored, or corroded. Keep terminals clean and tight.
9.Insulate all connections and disconnected wires.
10.Guard against electric shock. Prevent body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerator enclosures.
11.Use only Class BC or Class ABC fire extinguishers on electrical fires.
RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS (120 VOLT)*
FIGURE A
*Based on limiting the line voltage drop to five volts at 150% of the rated amperes.
MISC. PRECAUTIONS
1.
WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker.
2.
WARNING! The warnings and precautions discussed in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
SKU 93881 For technical questions, please call
