Chicago Electric 93881 operating instructions To Start The Engine/Generator, Figure F, Figure G

To Start The Engine/Generator:

1.Turn the Engine Fuel Valve Lever to its “OPEN” position. Then, turn the Engine Choke Lever to its “CHOKE” position. NOTE: No choke is required if the Engine is warm. Make sure the Engine Choke Lever is in the “RUN” position when starting a warm Engine. (See Figure F.)

ENGINE ENGINE

FUEL CHOKE

VALVE LEVER

LEVER

FIGURE F

2.Turn the Engine Power Switch (14) to its “ON” position. (See Figure G.)

3.Grasp the Handle on the Engine Pull-Start Cord and pull slowly until resistance is felt. Allow the Cord to rewind slowly. Then, pull the Handle with a rapid, full arm stroke. Allow the Cord to rewind slowly. If necessary, repeat this procedure until the Engine starts. (See Figure G.)

4.When the Engine starts, slowly turn the Engine Choke Lever to its “RUN” position. (See Figure G.)

5.IMPORTANT: Allow the Generator to run at no load for five minutes after each start-up so that the Engine and Generator can stabilize.

ENGINE	ENGINE
POWER	PULL-START
SWITCH	CORD
(14)

ENGINE

CHOKE

LEVER

FIGURE G

SKU 93881 For technical questions, please call 1-800-444-3353 PAGE 13