Specifications
Electrical Input | 120 V~ / 60 Hz / 4.2 A (Rated) |
|
|
Motor Speed | 2250 RPM (No Load) VSR |
|
|
Drive | 1/4” Hex |
|
|
Additional | All Ball Bearing Construction |
Features | Trigger Lock Switch |
| Metal Gear Housing |
| Removable & Adjustable |
| Depth Collar |
| 1/4” Magnetic Bit Holder |
Accessories | Phillips Bit (Qty. 4) |
| Slotted Insert Bit (Qty. 2) |
| E194601 |
ASSEMBLY INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION:
Unplug the Power Cord (43) from its electrical outlet before adding any accessories or making any adjustments to the tool.
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
To Change Bit Tip Holders:
1.Pull forward on the Depth Collar (2) and remove it from the Clutch Housing (5).
(See Figure A.)
2.Pull the Bit Tip Holder (4) straight out with pliers if it is difficult to remove.
(See Figure A.)
3.Push the new Bit Tip Holder (4) into the Spindle (7) until the shank of the Bit Tip Holder snaps in place. (See Figure A.)
4.Replace the Depth Collar (2) onto the Clutch Housing (5). Make sure to align the ribs on the inside of the Depth Collar with the grooves on the outside of the Clutch Housing before snapping the Depth Collar in place. (See Figure A.)
BIT TIP HOLDER (4) |
|
|
| BIT (3) |
|
|
| ||
|
DEPTH COLLAR (2)
SPINDLE
CLUTCH (7) HOUSING
(5)
FIGURE A
Page 8 | For technical questions, please call | SKU 9624 |
