9.When replacing the Saw Blade, make sure the new Saw Blade has a diam- eter of 10”, has an RPM rating of at least 4600, and has an arbor hole of 5/8” diameter.
10.To avoid accidental injury, always wear heavy duty work gloves when changing a Saw Blade.
11.Before using the Miter Saw, make sure the Saw Blade is properly mounted on the Saw Spindle. Make sure the Saw Blade is balanced, and is not cracked or bent.
12.The Saw Blade will become hot while cutting. Allow the Saw Blade to com- pletely cool before touching.
13.Allow the Saw Blade to spin up to full speed before feeding it into wood. When turning off the Miter Saw, allow the Saw Blade to spin down and stop on its own. Do not press against the Saw Blade to stop it.
14.Do not force the material into the Saw Blade when cutting. Apply moderate pressure, allowing the Saw Blade to cut without being forced.
15.Never attempt to remove material stuck in the moving parts of the Miter Saw while the machine is plugged in and running.
16.Whenever possible, use clamps or other safe, practical ways to hold and support the workpiece. Do not attempt to cut material that does not have a flat surface, unless a suitable support is used.
1. Turn off the Miter Saw and allow the Saw Blade to stop on its own if the
Saw Blade is to be backed out of an uncompleted cut.
18.Always keep hands and fingers away from the spinning Saw Blade.
19.Use eye, hearing, and breathing protection. Always wear ANSI approved safety impact eye goggles, hearing protectors, and dust masks or respirator when working with the Miter Saw.
20.Do not use this product if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not attempt to use this product.
21.Industrial applications must follow OSHA requirements.
22.Maintain this product with care. Keep the Miter Saw clean and dry for better and safer performance. For your safety, service and maintenance should be per- formed regularly by a qualified technician.
23.Use the right tool or attachment for the right job. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool or attachment. There are certain applications for which this product was designed. It will do the
SKU 90891 | For technical questions, please call | Page |
