Installation Instructions | RPAA1, B1, C1 |
ASSEMBLY AND INSTALLATION
Installing Threaded Pipe and RPAA1 Outer Sleeve
WARNING: IMPROPER INSTALLATION CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Structural members MUST be capable of supporting five times the combined weight of all equipment being mounted.
1.Install ceiling plate and extension accessories following installation instruction provided by manufacturer.
2.Remove drawer from RPAA1 outer sleeve. (See Figure 1)
2 |
Figure 1
3.Remove and keep security screw from bottom of RPAA1
sleeve. (See Figure 2)
Security
Tab
3 | Security | |
Screw | ||
|
4
Figure 2
4.Move security tab to right. (See Figure 2)
5.Align RPAA1 outer sleeve with end of NTP pipe. (See Figure 3)
6.Thread RPAA1 sleeve up onto pipe by turning counterclockwise until hand tight. (See Figure 3)
1
6
5
Figure 3
Rough Alignment of RPAA1
1.Turn RPAA1 sleeve clockwise or counterclockwise until the front of the RPAA1 is facing target. (See Figure 4)
Set
Screw
Figure 4
2.Tighten set screw. (See Figure 4)
3.Return security tab to left side (See Figure 5).
4.Replace and tighten security screw (See Figure 5).
5
