Chief Manufacturing CTA-100 Optional, Stacking Two Units, Stacking Three Units

Installation Instructions CTA-100

STEP 5 (OPTIONAL)

(10)

(70) (80)

CONNECT SECOND ATTACHMENT PLATE

TO BOTTOM CENTER PLATE OF CTA-100.

Figure 9. Install Second Attachment Plate

Stacking Two Units

Stack two units, as follows:

1.Locate the top attachment plate (10) for the second unit.

CAUTION

The stacked load cannot exceed 50lbs. (22.7kg).

2.Install the second attachment plate (10) on the center plate (20) of the first CTA-100 unit. Use four flat washers (70) and four M5 X 8mm button head cap screws (60). Tighten the screws. See Figure 9.

6. Tighten all cap screws (60).

WARNING

Failure to install and tighten the screws to secure your VCR/DVD can result in personal injury and/or equipment damage.

7.Check the CTA-100 to ensure that the side plates (30) and adjustment plates (40) are adjusted correctly. The unit should fit tightly around your VCR/DVD. If not, repeat steps 5 and 6 until your VCR/DVD is secure.

3.Attach the second CTA-100 to the second attachment plate (10). Use four flat washers (70), four M5 X 8mm button head cap screws (60). Tighten the screws.

4.Install your VCR/DVD into the CTA-100.

5.Adjust the side plates (30) and adjustment plates (40) as needed to secure your VCR/DVD safely in the CTA-100.

Stacking Three Units

Stack three units, as follows:

1.Perform the “Stacking Two Units” procedure to install the third CTA-100.

CAUTION

Do not stack more than three VCR/DVD mounts from a TV/Monitor mount. The stacked load cannot exceed 50lbs. (22.7kg).

2. Verify that all three units are secure.

9