Installation Instructions | Model: |
NOTE: The following steps reuse hardware set aside during existing mount preparation.
2.Place large Nylon washer into seat in pole mount front. (see Figure 4)
3.Slide pivot pin through large nylon washer and down into pole mount front. (see Figure 4)
4.Slide swing arm assembly down onto top of pivot pin.
5.Assemble two flat waskhers and one nylon washer onto button head cap screw. (see Figure 4)
6.While holding Nylock nut, previously installed into pole mount front, slide button head cap screw with washers through swing arm and down into pole mount front until contact with Nylock nut is made.
7.Secure swing arm to pole mount front by screwing button head cap screw into nylock nut.
NOTE: It may be necessary to move Nylock nut slighty in order to allow button head cap screw to properly seat in nut and allow tightening.
| Phillips BHCS |
| Flat Washer |
Swing Arm | Nylon Washer |
| Flat Washer |
| Pivot Pin |
Large Nylon Washer |
|
| Pole Mount |
Recessed Seat | (Front) |
|
Figure 4: Install Swing Arm to Front Pole Mount
8.Place pole mount front with swing arm against pole in approximate mounting location.
9.Place three BHCS (30) into pole mount rear (20) and place against pole aligning with mount front (10).
10.Secure pole mount rear (20) to pole mount front (10) and pole by tightening three BHCS (20) using 5/32" hex key.
Pole | (30) |
Pole Mount front (10) |
|
with Swing Arm |
|
| (20) |
Figure 5: Mount FSA-1017 with Swing Arm on Pole
ADJUSTMENTS
The
To adjust
1.Loosen single (right) rear BHCS (30). (see Figure 6)
2.Move
3.Tighten BHCS (30).
CAUTION!
ALWAYS use two people when adjusting
Adjustment Screw |
View From Rear |
Figure 6: Pole Mount Adjustment
3