Installation
Installation
To install batteries in the remote control:
1.Slide the battery compartment cover in the direction of the arrow to remove it.
2.Install two AA batteries with the correct polarity.
3.Replace the cover.
3.1
Remote Control
1. | 2. |
3. |
• Make sure that the battery polarities are correct when installing the batteries. | Notes on Batteries |
•Do not mix an old battery with a new one or different types of batteries.
•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.
• | In most situations, you can simply point the remote control at the screen | Notes on Remote Control |
| which will reflect the IR signal from the remote back toward the IR receiver on | Operation |
| the projector. In some cases, however, ambient conditions may prevent this. |
|
| If so, point the remote control at the projector and try again. |
|
• | If the effective range of the remote control decreases, or it stops working, |
|
| replace the batteries with new ones. |
|
• | The remote control may fail to operate if the infrared remote sensor is |
|
| exposed to bright sunlight or fluorescent lighting. |
|
Planar PD8130/PD8150 Installation/Operation Manual | 13 |
