iCMPFM1S/iCMPFM1B | Installation Instructions |
2 | 7 | X4, X6, X8 |
2 5
3 (S, U)
3 (R, T)
6
1
7 | X4, X6, X8 |
2 5
3 (S, U)
3 (R, T)
4 V, W
6
1
8 | (A, B) X2 |
9X4, X6, X8
INSTALL BRACKETS TO DISPLAY
1.Lay display face down on protective surface.
CAUTION: Using screws of improper diameter may damage your display! Proper screws will easily thread into display mounting holes.
2.Select screw diameter by examining hardware bags "A" through "D" (8mm, 6mm, 5mm, or 4mm) and comparing with mounting holes on display.
3.Select washers:
•6mm and 8mm diameter screws: Use flat washer
(U)and shoulder washer (T).
•4mm and 5mm diameter screws: Use flat washer
(S)and shoulder washer (R).
4.Select spacers:
•If mounting holes are not recessed, and both brackets (A and B) can lay flat against display, then no spacers are required.
•If mounting holes are recessed, or if protrusions prevent brackets (A and B) from laying flat, then spacers (V or W) must be used. Select shortest spacer which will provide adequate fill. All spacers must be same length.
CAUTION: Using screws of improper length may damage your display! Proper screws will have adequate thread engagement without contacting bottom of display mounting holes.
5.Select screw length:
•Using your hand, insert SHORTEST length screw of selected diameter (E, H, K, or N) through bracket (A or B), selected flat washer (S or U), selected shoulder washer (R or T), selected spacer (V or W, if required), into display mounting hole. Do NOT thread screw into hole at this time.
•Proper screw length requires base of screw head to protrude above flat washer a distance equal to or greater than the screw diameter. If screw length is inadequate, select longer screw. Select shortest screw which will protrude the required distance.
6.Place brackets (A and B) on display, ensuring:
•Upper hooks are towards top of display, and
•Hook plates are towards outside of display for mounting hole width up to
7.Using Phillips screwdriver, carefully install selected screws through flat washers, shoulder washers, brackets, and spacers (if required), into display. Do not tighten screws at this time.
8.Vertically center brackets (A and B) on display.
9.Tighten all screws. Ensure all applicable display mounting holes (4, 6, or 8) are used.
12
