Chief Manufacturing JHS Series Adjustments, Installation Instructions, Jhs Series

Installation Instructions JHS SERIES

1 x2

Figure 3

2.Align two screws in display back with upper mounting holes in Centris cup and lower display until screws are seated in lower area of teardrop mounting holes. (See Figure 4)

3.Install two more of the same screws through lower mounting holes in Centris cup and into display back. (See Figure 4)

4.Tighten all hardware.

5.Route cables and wires to display.

2

3

4

x 2

Figure 4

Adjustments

To adjust display Roll, Pitch, and YAW tension:

1.Disconnect all wires and cable from the display.

2.Remove two Lower screws securing display to Centris cup.

3.Loosen two Upper screws securing display.

4.Lift display upward and away from mount.

5.Using a hex head wrench turn the tension adjustment screw clockwise to increase tension, or counter-clockwise to decrease tension. (See Figure 5)

6.Re-install display.

Figure 5

5